hello@worcestergaragedoorpros.comMon–Fri 7:00 AM–10:00 PM ET · Sat 8:00 AM–10:00 PM ET · Sun 7:00 AM–9:00 PM ET
Dented sectional garage door panel
Home › Torsion Spring Repair

Torsion Spring Repair in Worcester, MA

The torsion spring is the coil mounted on a shaft above the garage door, and it does the heavy lifting: it winds up as the door closes and unwinds as it opens, carrying most of the door's weight. When it breaks — usually with a loud bang — the door will not lift. This page explains how a torsion spring is repaired properly.

Hours: Mon–Fri 7:00 AM–10:00 PM ET · Sat 8:00 AM–10:00 PM ET · Sun 7:00 AM–9:00 PM ET

Call now for garage door repair

Describe the door and the symptoms, and the visit will confirm what the door needs before any work starts.

Call Now

Serving Worcester and Worcester County, Massachusetts.

1
Local coverageWorcester and the towns around it, across Worcester County.
2
Whole-door inspectionEvery visit checks springs, cables, tracks, rollers and opener.
3
Emergency helpDoors stuck open, stuck shut, or hanging crooked — call to describe it.
4
Tested before leavingBalance checked by hand, full cycles run, safety reverse tested.

In short

Torsion spring repair means replacing the broken coil with a new spring matched to the door's weight, height and cycle rating, wound to the correct number of turns, with the door rebalanced by hand afterwards. On a two-spring door both springs are replaced together.

How a torsion spring works

A torsion spring is a heavy steel coil mounted on a metal shaft directly above the garage door opening, inside the garage. When the door closes, the spring winds up and stores energy; when the door opens, it unwinds and lifts most of the door's weight. The opener only guides the door and holds it in position — the spring does the lifting. That is why a broken torsion spring leaves the door immovable: the opener was never doing the heavy work. Torsion springs are rated by cycle life, commonly around 10,000 open-close cycles, and a door used four times a day reaches that rating in about seven years. The spring is sized to the door by three numbers — wire size, inside diameter and length — and all three must match, or the door will be over-sprung or under-sprung.

Signs a torsion spring is failing

The loud bang is the classic sign: a torsion spring snapping sounds like a firecracker inside the garage. After the bang, the door will not lift, or lifts a few inches and stops. The visual check confirms it — look at the spring above the door for a clear gap in its coils, usually about two inches wide, where the steel separated. Quieter signs come first: a door that feels heavier than it used to, a door that drifts down when it should hold steady at waist height, a spring that groans or squeaks through its travel, or rust along the coils, especially at the ends. A door that worked yesterday and will not move today has usually lost its spring overnight, because springs most often snap when the door is at rest and the metal is cold.

What the repair visit includes

The door is secured first — clamped in its tracks so it cannot move while the tension is released. The old spring is unwound with winding bars in controlled quarter-turns, removed from the shaft, and replaced with a new spring matched to the door's weight, height and cycle rating. On a two-spring door both springs are replaced together, because the surviving spring has the same age and cycles and will break soon after. The new spring is wound to the correct number of turns for the door's height, then the door is balanced by hand: it should lift with moderate effort, hold steady at waist height, and lower smoothly. The opener is reconnected, run through full cycles, and the safety reverse is tested. The cables, drums and bearings are checked at the same time, because they share the spring's workload.

Why torsion spring repair is not a do-it-yourself job

A torsion spring stores enough energy to cause serious injury, and the repair is a matter of procedure and tools, not strength. The spring is wound under tension with steel winding bars, and if a bar slips or a set screw is loosened in the wrong order, the spring unwinds in a fraction of a second. The winding must also be exact: too few turns and the door is heavy, too many and the door flies up and strains the opener. The number of turns depends on the door's height and the spring, and it is not something to guess. A spring of the wrong wire size or length will wear out the opener, bend the tracks, or leave the door crooked. Of all garage door repairs, the torsion spring is the one where professional help is least optional.

How long a new torsion spring lasts

A new torsion spring matched to the door should last roughly its rated cycle life — commonly around 10,000 cycles, about seven years at four cycles a day. Rust is the biggest life-shortener in Worcester, where road salt and snowmelt keep the garage damp through the winter. A spring that is lubricated a few times a year resists rust and runs with less friction. The second life-shortener is the wrong match, and the third is imbalance: a door that was never rebalanced after a repair runs crooked and stresses one side. The habits that extend a spring's life are simple — lubrication, a visual check for rust and gaps, and a balance test twice a year.

How it works

What happens on a garage door repair visit

1Call

Describe the door and the symptoms — what happened, when, and what the springs and cables look like.

2Inspection

The visit checks the whole door system and names the failed part before any work starts.

3Repair

The failed part is repaired or replaced, matched to the door, and the door is rebalanced by hand.

4Testing

Full open and close cycles, balance checked, safety reverse tested — the door proves it works.

Related services and guides

Frequently asked questions

Look at the coil above the door: a broken torsion spring shows a clear gap in its coils. The other signs are a loud bang from the garage and a door that will not lift, or lifts a few inches and stops.

Yes, on a two-spring door. The surviving spring has the same age and the same number of cycles as the one that broke, so it is likely to break soon after. Replacing both means one visit and a balanced door.

Yes. A torsion spring stores a large amount of energy under tension, and a winding bar that slips or a set screw loosened in the wrong order can cause serious injury. Spring replacement is a professional repair.

It depends on the door's height and the spring itself — there is no single number. The correct winding is set by the door's measurements, and the balance test afterwards confirms it: the door should hold steady at waist height when lifted by hand.

Call now for garage door repair in Worcester, MA

Describe the door and the symptoms, and the visit will confirm what the door needs before any work starts.

Call Now

Contact

Call to describe the door and the symptoms, and the visit will confirm what the door needs before any work starts. Hours: Monday to Friday 7:00 AM to 10:00 PM ET, Saturday 8:00 AM to 10:00 PM ET, Sunday 7:00 AM to 9:00 PM ET.

hello@worcestergaragedoorpros.com · Serving Worcester and Worcester County, Massachusetts.

Call Now
☎ Call Now
Garage door help — Worcester, MA